Which actions must be performed to implement SNMP access to the router? (Choose two)

Which three statements accurately describe Layer 2 Ethernet switches? (Choose three)

Which of the following are required attributes of a REST-based API? (Choose two)

You are currently converting an IP address to the binary format. What is the binary value of the decimal number 176?

Which hash method is used by default when using the enable secret Cisco IOS command?

In a split-MAC architecture, real-time functions such as encryption are handled in which of the following network entities?

A Cisco Catalyst switch connects to what should be individual user PCs. Each port has the same port security configuration, configured as follows:
interface range gigabitethernet 0/1 - 24
switchport mode access
switchport port-security
switchport port-security mac-address sticky
Which of the following answers describe the result of the port security configuration created with these commands? (Choose two)

In a switched environment, what does the IEEE 802.1Q standard describe?

Suppose two APs are located near each other. Which channel use strategy will result in nonoverlapping channels for Wi-Fi use? (Choose two)

To connect a Cisco wireless LAN controller to a wired network, which of the following would you use? Assume that this connection will carry traffic to and from APs.

Which statements describe neighbor discovery functionality in IPv6? (Choose two)

Which command is used to view the neighbor discovery table on a PC?

R3 has a static route configured that points toward the service provider. What command could you use to have R3 advertise an OSPFv3 default route to the internal network, regardless of whether R3 had its default static route?

What considerations should be taken in account while designing VLANs? (Choose three)

Which of the following identifications can be used with Extended ACL? (Choose two)

You receive a notification that there is an issue in one of your switched networks. After reviewing the logs you noticed that a switch has rebooted; however, there is no network connectivity to the resources attached to that switch anymore. You connect to the switch over the management network and notice that there is the following message:

Would you like to enter the initial configuration dialog? [yes/no]:

What is the reason for receiving this message?

You have implemented DAI on a Layer 2 switch in your network. Now you want to monitor the ARP message rates with an average of four received ARP messages a second. Which command(s) would need to be utilized to accomplish this? (Choose two)

Of the figures shown, which depicts an accurate Clos Architecture?

Which IOS command always displays OSPF hello timer settings?

What are some of the wireless LAN controller (WLC) capabilities?

If you take the network 192.168.1.0/24 and create four subnets from it, what are the new subnet IDs? (Choose four)

What command is used to verify MAC address table entries?

If you want to be alerted when a device configuration differs from the intended configuration, what should you implement?

What are the valid encapsulation methods when forcing a device to become a trunk port? (Choose three)

Which of the following commands is used to enable a serial interface?

Which statements correctly define VLANs? (Choose two)

Review the topology. All subnets exist in OSPF area 0. Which command, if issued on R3, would show all the LSAs known by R3?

Identify the protocols that can negotiate EtherChannel creation and maintenance. (Choose two)

Which of the following behaviors are applied to a low latency queue in a Cisco router or switch? (Choose two)

An enterprise plans to start using a public cloud service and is considering different WAN options. The answers list four options under consideration. Which one option has the most issues if the company chooses one cloud provider but then later wants to change to use a different cloud provider instead?

When comparing controller-based networks and traditional networks what are some perceived benefits from a controller-based perspective? (Choose two)

The CLI is used to enter commands. Identify the command entry functions of the Cisco CLI. (Choose two)

Which port number is used by SSHv2?

Which two are features of IPv6? (Choose two)

Which Cisco IOS command is used to configure an IPv4 address on a Cisco ISR?

Routing tables can be populated in a number of different ways. Which of the following describes the local host routes route type.

Which OSPF verification commands describe the operations they perform? (Choose two)

Which statement is true about the addresses 172.16.0.255/23 and 172.16.1.0/23?

Which DSCP marking group was created to be backward compatible with Internet Protocol Precedence (IPP) values?

Imagine you configured OSPFv2 in a small lab network. Which of the following answers list a condition that could keep the routers in your lab from learning all the routes to all the IPv4 routes in your small lab network? (Choose two)

What Inter-VLAN routing method uses a single physical link between a router and a switch?

Which of the following route types is used when the route is manually configured by a system administrator?

Which cloud service model provides access to an application that is built, monitored, and offered by the cloud provider?

During a maintenance window, you make some changes to R2. You document these changes in your configuration management system. Later that night, you are called in to fix an issue that requires you to make additional changes to R2. The next morning your co-worker addresses another issue but this time on R1. All of these changes are documented properly but neither you or nor your coworker discuss the changes. These changes stay implemented for months. What is this best described as?

Refer to the exhibit. A technician is troubleshooting host connectivity issues on the switches. The hosts in VLANs 10 and 15 on Sw11 are unable to communicate with hosts in the same VLANs on Sw12. Hosts in the Admin VLAN are able to communicate. The port-to-VLAN assignments are identical on the two switches. What could be the problem?

Which command could you enter to encrypt passwords?

You need to configure a banner on your IOS Switch indicating that maintenance will be performed on Saturday night.
Which banner is the best to implement in this case?

Which IEEE standard protocol is initiated as a result of successful DTP completion in a switch over Fast Ethernet?

In a reflection attack, the source IP address in the attack packets is spoofed so that it contains which one of the following entities?

When establishing a translation between an inside local and inside global address with Port Address Translation, what keyword must be used with the ”ip nat inside source” command to enable PAT?

What is the name of the Cisco feature that allows for the identification of protocols that are traditionally hard to classify because of their operation?

You need to back up the Cisco IOS image of your Catalyst switch to a tftp server. Where is the Cisco IOS image stored?

Which command is used to set an inactivity timer for the vty lines on your Cisco IOS switch?

Of the different public cloud WAN options, which have quality of service capabilities to ensure end-to-end application requirements? (Choose three)

Which of the following attributes do QoS tools manage? (Choose three)